Contact us
send us a message
send us a message
They knew that in the Levante area it is one of the areas of Europe that has more lime in the water that is what causes the breakage of electric water heaters, washing machines, heaters the best solution is to place a (Resin Disqualifier € 1200 Also We install there are cheaper electricity for € 300 but they are not so effective I particularly have it in my house and I have been with the same thermos for 18 years and the washing machine for 12 years, but when it is not economically possible, cleaning is used with a special machine and it costs about € 150 for a house of about 150 square meters including the gas heater.
Lime is released from the water after 72 degrees and when it becomes embedded in tubes and resistors, heaters, electric water heaters, etc. That is why it is important not to have the temperature regulated too high in the appliances, apart from that they consume more energy and last less years of life.
Cleaning heaters and lime circuits is very common in homes where there are water heaters, this must be done with a specific machine for this purpose, with acids and with a pump in the opposite direction of the water in its working conditions.
Important note must be done while the water still passes through the installation in a certain proportion, since if you wait to do it too late, the acid will not be able to penetrate and pass through the lime plug, and consequently it will not be able to eliminate it and then it comes the worst, would have to do a whole or partially new installation, and breaking walls and floors causing all these unnecessary expenses.
Ordinary Economic Plumbing Services and emergencies 24 Hours from Monday to Sunday special communities.
We are certified and certified gas and water network installers for Butane and Propane installations
Services in Altea and Benidorm, as well as the rest of the towns in the province such as Denia, Javea or Alicante.
CHECKS YOU CAN DO:
- If there is a leaking faucet inside and outside the house as well as the garden If you have a toilet or toilet leaking or leaking water If this happens to you at home, you must fix it and you can also call us for these services that we also do very economical. If all this does not happen to you, you have already noticed an increase in spending, in the bill and in the consumption of water lately. If the water supply company has announced the increase in your consumption. So if you should call us and you can do it at any time.
Savings for your pocket!
If there is a leak, the agreement will be charged for locating it with tracer gas, ultrasound, thermography and other means of location that the technician considers.
In this way you have the possibility of being able to save the expenses of the localization. If you really do not have a leak, doing the tightness test and knowing that there is no leakage, it is not necessary to spend gas, and consequently only € 80 will have been spent.
It usually occurs in 20% of cases, for example, leaky toilets or taps.
PARAMETERS
Note: These prices are for pipes of a maximum of 50 mm. and not more than 100 m. linear or the entire circuit, that is, homes not exceeding 150 m2.
Note: If the work to be carried out exceeds or exceeds these parameters, and no location service is carried out, only the tightness test, it will be known if there is leakage or not and a budget will be made on site, and at the moment free of charge to locate the water leak and € 120 will be paid for the tightness test carried out.
Pool Leak Rates:
No maximum of 10 X 5 wide x 2.50 deep.
Water leaks and their rates:
Tightness test:
With water to check if there is a leak in the installation and € 400 will be charged, if any, € 200 more will be charged for locating it with tracer gas or other methods such as ultrasound or thermal imaging cameras, if it is full they must notify me.
In this way you can save the costs of location and gas € 200 since it would be known if there is no leak in the installation and it can be in the structural pool of the pool
Note: If these parameters (measurements) are exceeded or the work to be carried out and no service of any kind is carried out after having moved, a specific budget would be made at the moment or by email for your particular case, paying € 80.
Displacement € 25 max. 25 km. more route consult.
Note: At these prices the VAT tax will be increased and the repair or parts are not included, a separate estimate would be made for the repair of the fault.
With ultrasound method and characteristics of success.
All solid solid are good transmitters for ultrasound?
in this order:
Concrete, marble. stoneware, terrazzo etc. Well
Asphalt, solid ground. Regular or rather on the bad side.
Parquet or laminate of wood or very bad synthetics is more difficult to locate the water leak.
In general, it is established that around 90% of water leaks, in a pressurized network, generate noise. The electro-acoustic leak detection method consists of the exact location of this noise source and, therefore, of the leak. By means of a geophone with a high amplification capacity, it is possible to detect and precisely locate the breaking points of a water network, but the terrain does not always favor the work depending on its transmission of sounds, for example.
With the Tracer Gas Method it will be used when the leak does not guarantee to locate it in the exact point due to the little confusing sound it produces, it depends on many factors and a budget is made on site to do it with tracer gas.
With The Tracer Gas Method And Its Success Characteristics
Equipment developed for the detection of leaks by revision of any type
From network or tank that requires airtightness to detect leaks
Complex in supply networks or in domestic installations, a tracer gas can be used. This gas consists of a mixture of 5% Hydrogen (H2) and 95% Nitrogen (N2). Why is this mixture used?
Simply because hydrogen is the gas that offers the most advantages.
The main reasons are as follows:
Toxicity:
- Hydrogen is not toxic and does not present contraindications against the environment. Its use is authorized in drinking water facilities and intended for human consumption. Inspection of private networks, such as: Houses, chalets, shops, farms, connections, etc.
The procedure consists of filling the pipe to be checked with this mixture.
It is convenient to verify with the equipment, at the end opposite the filling end, that the mixture has completed the installation. Subsequently, the
Pressure up to about 2 bars. The higher the filling pressure, the faster the detection.
Hydrogen is a gas with a high molecular speed and the lowest viscosity. These properties allow it to pass through all kinds of materials to the surface.
The H2 / N2 mixture is inert.
Hydrogen does not exist in the environment so it is not possible to produce false positives.
Attention Pools ¡¡¡
Evaporation of water in a swimming pool or leaks or leaks and its consequences
Evaporation is a physical process that always affects water, whatever the conditions. That is why we should not be surprised if the water level in our pool drops a bit, as it will be suffering from evaporation. The factors that influence the evaporation of water in the pool depends on the area in which you live in Spain. We can differentiate 3 large areas, the north area, the central area and the southern area, taking into account that the influencing factors are:
- The climatic conditions of the locality. The hours of sunshine that the pool may have per day. Average of the pool and depth of the same.
From time to time calculating the evaporation of the water in our pool can be beneficial, because in this way we can discover if we have any leakage or loss of water or if, on the contrary, everything is working correctly and we are simply facing an evaporation of natural water. To calculate the evaporation of water in swimming pools there are different ways, in Plumbers Benidorm we are going to see one of them that is available to everyone and you will be able to diagnose the evaporation of your pool.
Calculation of the evaporation of water from a swimming pool
If you do not have the means to do it yourself, we also do these tests at a cost of € 150
The steps to perform this test are as follows. Keep in mind that if it rains you will have to repeat the test and also if it is a windy day.
- Fill the pool to its normal level Fill a 20 liter bucket with pool water Place the bucket on the first or second step of the pool (preferable on the second, no immersion) Mark the water level in the bucket with electrical tape inside the bucket. Turn off the pump and mark the pool water level on the outside of the bucket. Resume normal pump operation. Make sure the automatic pool fill is turned off during the test, after 24 hours check the levels. The marks on the inside and outside of the hub must descend in the same proportion, otherwise there may be a leak.
To know the liters of water we lose per day, very simple. We look at an example with data for a 10 × 5 meter pool and suppose that the pool level has dropped 2.85 cm in one week. The volume of water that we have would be (width x height x depth) of 1425 liters. Take into account that a cubic decimeter of water is a liter of water. In one day we have lost about 204 liters of water.
At this point, it should be noted that natural evaporation will cause us to have a water loss of between 2.5 and 3.75 cm per week. The moment we notice that these parameters vary, that is when we can choose to carry out the relevant tests. If we discover that there is a leak, it will be time to go to a professional to find the exact point and fix it. If, on the other hand, everything follows its natural course, then let's simply continue enjoying our pool as before.
I hope it helps you to know if you have water leaks or not, if you do, call the phone: 600582020